Installing memory and font DIMMs
Installing memory and font DIMMs
You can install more memory for the printer, and you can also install a font DIMM to print characters for languages such as Chinese, or for the Cyrillic alphabet.
| CAUTION |
Static electricity can damage DIMMs. When handling DIMMs, wear an antistatic wrist strap, or frequently touch the surface of the DIMM antistatic package and then touch bare metal on the printer. |
|---|
| 1. | Print a Configuration page by pressing  (Select) and  (Cancel Job) simultaneously. (A Supplies Status page and possibly an HP Jetdirect Configuration page also print.) If the Configuration page does not print in your language, see Device pages and reports.
|
| 2. | After the Configuration page prints, turn the printer off and disconnect the power cable.
|
| 3. | On the left rear side of the printer, open the DIMM door.
|
| 4. | Release the locks on each side of the DIMM slot.
|
| 5. | Remove the DIMM from the antistatic package.
|
| 6. | Holding the DIMM by the edges as shown in the illustration, align the notches on the DIMM with the DIMM slot.
|
| 7. | Firmly press the DIMM straight into the slot. Firmly close the locks on each side of the DIMM until they snap into place.
|
| 8. | Close the DIMM door.
|
| 9. | Reconnect the power cable and turn the printer on.
|
| 10. | Go to Checking DIMM installation. |
